Installation Guide

ManualsBrandsVaxcel ManualsOutdoor Wall SconcesVaxcel Lighting Cadiz 1 Light Outdoor Wall Sconce - 11.63 Inches Wide

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0087

Back Plate

Ball Nut (G)

Bulb Type A Max.100W

(not included)

Rubber Pad (H)

Parts:

140324

Parts Number (5007MM)

Mounting Screw (B)

Green Grounding

Screw (C)

Lock Nut (F)

Wire Nut (E)

Cross Bar (A)

Ball Nut (G)

Metal Frame

Headless Screw (D)

Parts Number (9577CE)

Rubber Pad (H)

Photocell

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

Ball Nut Assembly

Fixture

Cross Bar (A)

House Grounding Wire

Green Grounding Screw (C)

Fixture Grounding Wire

Wire Nut (E)

Outlet Box

Fixture Wire

Mounting Screw (B)

Lock Nut (F)

Headless Screw (D)

Parts Number (9578AM)

Clip

Glass Holder

Exterior Glass Shade (J)

Interior Glass Shade (I)

Exterior Glass Shade (J)

Interior Glass Shade (I)

Fig. 1

Metal Frame

Clip

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

Summary of content (3 pages)

PAGE 1
T0087 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
1. Thread two headless screws through the cross bar, then secure them with four lock nuts (two on each side of the cross bar). Adjust the length of the headless screws if necessary. Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will be level. 2. Attach the cross bar to the outlet box by using two mounting screws. 3. Place the exterior glass shade into the metal frame carefully, and then secure it by pressing the clips from the top sides. (See Fig.
PAGE 3
. Take a white pigtail and black pigtail and make wire connections using wire nuts: (See Fig.3) a. The black wire from the fixture to one end of the black pigtail. b. The white wire from the fixture to one end of the white pigtail. c. The other end of the black pigtail to the black wire from the power source. d. The other end of the white pigtail to the white wire from the power source. Put all wires back into the back plate of the fixture.