Installation Guide

ManualsBrandsVaxcel ManualsOutdoor Wall SconcesVaxcel Lighting Trail Single Light 13" High Outdoor Wall Sconce with Horse and Rider Accents

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0110

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

141028

Cross Bar(A)

Green Grounding

Screw (C)

Headless Screw(E)

Ball Nut(G)

Mounting Screw (B)

Wire Nut (D)

Lock Nut (F)

Rubber Pad (H)

Seeded Glass

Fixture

Rubber Pad

Ball Nut(G)

(H)

Fixture Wire

Wire Nut (D)

Fixture Grounding Wire

Headless Screw (E)

Cross Bar (A)

Lock Nut (F)

Outlet Box

House Grounding Wire

Green Grounding Screw (C)

Mounting Screw (B)

Lock Nut

Set Screw

Loop

Washer

Curved Arm

Bulb Type A Max.60W

(not included)

Turn off the power at fuse or circuit box.

1. Thread two headless screws through the cross bar, then secure them with four lock nuts ( two on each side of the

cross bar). Adjust the length of the headless screws if necessary.

Note: Make sure that the headless screws are lined up horizontally, to ensure that the fixture will be level.

2. Attach the cross bar to the outlet box by using two mounting screws.

3. Hook the curved arm to the loop, and then attach the curved arm to the back plate by using the set screw, washer

and the lock nut.

4. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follow:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the cross bar with the green grounding

Back Plate

Installation Steps

Summary of content (2 pages)

PAGE 1
T0110 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
screw. Then connect it to the house grounding wire with the wire nut. Carefully put the wires back into the outlet box. 5. Attach the back plate to the cross bar by inserting the headless screws, then secure it with rubber pads and two ball nuts. CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall surface to prevent water from seeping into the outlet box. 6. Install bulb (not included).