Installation Guide

ManualsBrandsVaxcel ManualsOutdoor Wall SconcesVaxcel Lighting York 1 Light 8" Wide Outdoor Wall Sconce

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0154

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

141107

Green Grounding

Screw (C)

Ball Nut(G)

Mounting Plate(A)

Green Grounding Screw(C)

Fixture Grounding Wire

Wire Nut(D)

Socket

Socket Ring

Fixture

Glass Shade

Outlet Box

Fixture Wire

Mounting Screw(B)

Lock Nut(F)

Headless Screw(E)

Back Plate

Rubber Pad(H)

Turn off the power at fuse or circuit

Installation Steps

Bulb Type A Max.60W

(not included)

Mounting Plate (A)

Mounting Screw (B)

Headless

Screw (E)

Wire Nut (D)

Ball Nut (G)

Lock Nut(F)

Rubber Pad(H)

1. Thread two headless screws through the mounting plate, then secure them with four lock nuts (two on each side of

the mounting plate). Adjust the length of the headless screws if necessary.

2. Attach the mounting plate to the outlet box by using two mounting screws.

3. Pull out the wires and grounding wire from the outlet box. Make wire connections using the wire nuts, as follow:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green

grounding screw. Then connect it to the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

4. Attach the back plate to the mounting plate by inserting the headless screws, then secure it with two rubber pads and

two ball nuts.

CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the

wall surface to prevent water from seeping into the outlet box.

5. Place the glass shade to the fixture carefully, secure it by using socket ring.

6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.

Turn on the power at fuse or circuit box.