Installation Sheet

ManualsBrandsVaxcel ManualsShop All Outdoor LightingVaxcel Lighting Athene 2 Light Integrated LED Outdoor Flood Light

Page 1 / 6

180720

Important to Know:

1. If you are not familiar with state and local electrical

codes, it is recommended that you consult with a

qualified electrician.

2. This fixture requires a 120 VAC, 60 Hz power

source.

3. For general safety and to avoid any possible

damage to the sensor, be sure the power is

switched "off" before adjustment.

Maximum Wattage: 22 W

Working Temperature Range: - 4°F ~ 113°F

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0436

Features:

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Note: Fixture can be wall mounted only.

1. Energy saving LED fixture.

2. Motion sensor: turns light ON automatically when

motion is detected and turns light OFF automatically

when motion stops.

3. Photocell keeps the light OFF during daylight hours.

4. When in manual override mode, use wall switch

to change the function and perform the function

conversion.

Hardware Package (included):

Fixture Mounting Screw

Mounting Strip

Wire Connector

Mounting Screw

Wall Mounted

Read notes section on page 2 for additional

information about mounting location of fixture.

Light fixture should be mounted as shown when

installed.

Decorative Cover

Summary of content (6 pages)

PAGE 1
T0436 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Hardware Package (included): Fixture Mounting Screw X1 Mounting Screw X2 Mounting Strip X1 Wire Connector X3 Decorative Cover X1 Important to Know: Features: 1.
PAGE 2
Wire Connector(G) FRONT Decorative cover Fixture Mounting Screw Outlet Box Mounting Strip Mounting Screw Installation Steps Turn off the power at fuse or circuit box. 1. Install the mounting strip to the outlet box with the stamped word “FRONT” facing away from the outlet box, using two mounting screws that best fit the outlet box. Back plate should sit flush against wall surface when secured. (Choose one matching pair of suitable mounting screws from the 3 pairs provided) 2.
PAGE 3
Function and Operation 1. TEST MODE (daytime and nighttime operation.) ● With the power on, the owl’s eyes turn to low-level brightness automatically and wall light is always on. ● The owl’s eyes and wall light turn to high-level brightness when motion is detected, and stay on as long as the motion continues. Then the owl’s eyes switch back to low-level brightness about 5 seconds after motion is no longer detected. 2.
PAGE 4
Fig.8 Be sure the light is mounted straight on the wall otherwise, the detection distance may be limited. Fig. 6 10.0' 6.0' 5' Motion Motion Fig.7 120 ˚ Least sensitive 40' Sensor Most sensitive TROUBLE SHOOTING Problem The light will not come on. The light comes on during the day. The light comes on for no apparent reason. The light turns off too late in the PC setting. Possible Cause Solution The light switch is turned off. Turn the light switch on.
PAGE 5
Problem The light stays on continuously. The light flashes on and off. The light flashes once then stays off in manual mode. Possible Cause Solution The motion sensor may be picking up a heat source, such as an air vent, dryer vent, or brightly painted, heat-reflective surface. The motion sensor is in manual mode. Decrease the “SENSITIVITY” setting or reposition the motion sensor. The light fixture is wired through a dimmer or timer. Do not use a dimmer or timer to control the light fixture.
PAGE 6
5-YEAR LIMITED WARRANTY: All products are warranted to be free of defects in material and workmanship for five (5) years from date of purchase. This warranty is limited to the correction of any such defect, or the replacement of any such defective item(s), provided that: (a) we are properly notified and consent to return of the item(s) in question:(b) the item(s) is / are returned with proof of purchase date; and (c) it is found upon inspection by us that the item(s) is / are defective as noted above.