Installation Sheet

181126

Turn on the power at fuse or circuit box.

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Mounting Hardware

6056MM (1SET)

Glass Shade

10073RG (2PCS)

Glass Shade

10072RG (2PCS)

1. Thread two headless screws (D) through the cross bar (A), then secure them with four lock nuts (E) (two on each side

of the cross bar). Adjust the length of the headless screws (D) if necessary.

2. Attach the cross bar (A) to the outlet box by using two mounting screws (B).

3. Slip the fixture and one end of the curved arm through the nipple and secure them with the finial. Then secure the

other end of the curved arm to the back plate by using the set screw and lock nut.

4. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections using the wire

connectors (F):

---Connect the black wire from the fixture to the black wire from the power source.

---Connect the white wire from the fixture to the white wire from the power source.

---Attach the fixture grounding wire to the cross bar with the green grounding screw (C). Then connect it to the house

grounding wire with a wire connector (F).

Carefully put the wires back into the outlet box.

5. Attach fixture to the wall by aligning headless screws (D) on cross bar (A) with holes on back plate. then secure it

with two rubber pads (H) and two ball nuts (G).

CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the

wall surface to prevent water from seeping into the outlet box.

6. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.

Turn off the power at fuse or circuit box.

Installation Steps

Green Grounding

Screw (C)

Headless screw (D)

Mounting Screw (B)

Wire Connector (F)

Lock Nut (E)

Ball Nut (G)

Cross Bar (A)

Rubber Pad (H)

A:7"

B:14-1/2"

C:7-3/4"