Manualshelf

Installation Guide

ManualsBrandsVaxcel ManualsShop All VaxcelVaxcel Lighting Lexington Single Light 11" Wide Semi-Flush Ceiling Fixture
12
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
200120
T0537
W
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
WARNING:
TO A L SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ
AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Mounting Strap Unit (A) Mounting Screw (B) Wire Connector (C)
Bolt Nut (D) Rubber Pad (E)
1. Remove the two bolt nuts (D), the two rubber pads (E) and the
mounting strap unit (A) from the canopy.
2. Attach the mounting strap unit (A) to the outlet box using two
mounting screws (B).
3 Take a glass panel and gently slide it into the metal
frame in place,secure it by pressing two clips on top side of
the metal frame and two clips on the bottom of the metal
frame. Repeat with the other glass panels. (See Fig.1 and Fig.2)
4. Pull out the source wires from the outlet box.
Make wire connections using wire connector (C) as follows:
--- Connect the black wire from the fixture to the black wire
from the power source.
--- Connect the white wire from the fixture to the white wire
from the power source.
--- Attach the fixture grounding wire to the mounting strap
unit (A) with the green grounding screw, then connect
it to the house grounding wire with a wire connector (C).
Carefully put the wires back into the outlet box.
5. Attach the canopy to the mounting strap unit (A) by inserting
the headless screw, then secure it with two rubber pads (E)
and two bolt nuts (D).
6. Install the bulb (not included). Check relamping label at socket
area or packaging for maximum wattage allowed .
Turn off the power at fuse or circuit box
Turn on the power at fuse or circuit box
Installation Steps
Outlet Box
House Grounding Wire
Wire Connector (C)
Headless Screw
Mounting Strap Unit (A)
Green Grounding Screw
Lock Nut
Mounting Screw (B)
Lock Nut
Canopy
Bolt Nut (D)
Rubber Pad (E)
Fixture
Metal Frame
Max.60W Type A Bulb
(not included)
Glass Panel

Summary of content (2 pages)