Installation Guide

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

T0540

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

Wire Connector (C)

House Grounding Wire

Outlet Box

Mounting Screw (B)

Green Grounding Screw

Headless Screw

Mounting Plate Unit (A)

Fixture Wire

Fixture Grounding Wire

Glass Panel

Backplate

Photocell

Fixture

Rubber Pad (E)

Bolt Nut (D)

Set Screw

Metal Frame

Max.60W

Type A Bulb

(not included)

Hardware Package (included):

Mounting Screw (B) Wire Connector (C) Bolt Nut (D) Rubber Pad (E)Mounting Plate Unit (A)

Fig.1

Clip

Metal

Frame

200120

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0540 W WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
Installation Steps Turn off the power at fuse or circuit box. 1. Remove the two bolt nuts (D), the two rubber pads (E) and the mounting plate unit (A) from the backplate. 2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Note: Make sure that two set hole are lined up horizontally to make the fixture level. 3. Unscrew the two set screws and remove metal frame from the fixture.
PAGE 3
The following parts are available for re-order if damaged or missing.