Installation Guide

191127

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

Hardware Package (included):

Mounting Screw (B)

Rubber Pad (E)

Cross Bar Unit (A)

Wire Connector (C) Bolt Nut (D)

T0541 / T0543

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

Installation steps

1. Remove the two bolt nuts (D), the two rubber pads (E)

and the cross bar unit (A) from the backplate.

2. Attach the cross bar unit (A) to the outlet box using

two mounting screws (B). Adjust the length of the

preinstalled headless screws if necessary.

Note: Make sure that the headless screws are lined

up horizontally to make the fixture level.

Turn off the power at fuse or circuit box.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ

AND SAVE THESE INSTRUCTIONS.

Wire Connector (C)

House Grounding Wire

Outlet Box

Mounting Screw (B)

Green Grounding Screw

Headless Screw

Cross Bar Unit (A)

Fixture Wire

Fixture Grounding Wire

Backplate

Bolt Nut (D)

Rubber Pad (E)

Socket

Glass Shade

Metal Frame

Set Screw x 3

Fixture

Max.60W Type T Bulb

(not included)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0541 / T0543 W WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
3. Remove the three set screws and the metal frame from the fixture. 4. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows: • Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source. • Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.