Instructions / Assembly

Page 2 / 2

Turn off the power at fuse or circuit box

Turn on the power at fuse or circuit box

Installation Steps

1. Unscrew the two set screws (D) and remove the mounting plate unit (A) from the backplate.

2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B).

Note: Make sure that two set holes are lined up horizontally to make the fixture level.

3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:

• Connect the hot wires (black insulation) from the fixture to the black wire from the power source.

• Connect the neutral wires (white insulation) from the fixture to the white wire from the power source.

• Attach the fixture ground wire (bare wire) to the mounting plate unit (A) with the green ground screw，

then depending on local code, connect it to the house ground wire with the wire connector (C).

Carefully put all of the wires back into the outlet box.

4. Attach the backplate of the fixture to the mounting plate unit (A) by aligning holes, secure the two set screws (D)

from the side hole of the backplate into the hole in the side of the mounting plate unit (A).

Note: With silicone caulk compound, caulk completely around where the backplate meets with the wall

surface to prevent water from seeping into the outlet box.

5. Remove the cover from the fixture.

6. Install the bulbs (not included). See relamping label at socket area or packaging for maximum wattage allowed.

7. Attach the cover back to the top of the fixture carefully.

The following parts are available for re-order if damaged or missing.

Spare Parts List:

Set screw (D)

Mounting Screw (B)

Wire Connector (C)

Mounting Plate Unit (A)

Assembly Kit

6594MM (1 SET)

A: 14"

B: 4-3/4"

C: 5-1/2"

221024