Use and Care Manual

Page 1 / 3

231124

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

Hardware Package (included):

Mounting Screw (B) Wire Connector (C) Bolt Nut (D)

Rubber Pad (E)

Crossbar Unit (A)

T0750 / T0751

WARNING: Turn off the main power at circuit breaker before installing fixture.

AVERTISSEMENT: Coupez la source d’alimentation principale au panneau

central de disjoncteurs avant d’installer le luminaire.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Read

and save these instructions.

Wire Connector (C)

House Ground Wire

Outlet Box

Mounting Screw (B)

Green Ground Screw

Fixture Mounting Screw

Crossbar Unit (A)

Fixture Wire

Backplate

Fixture Ground Wire

Rubber Pad (E)

Bolt Nut (D)

Socket

Shade

Sokcet Ring

Max. 60W Type A Bulb

(included)

Photocell

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0750 / T0751 W WARNING: Turn off the main power at circuit breaker before installing fixture. AVERTISSEMENT: Coupez la source d’alimentation principale au panneau central de disjoncteurs avant d’installer le luminaire. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Read and save these instructions.
PAGE 2
Installation Steps Turn off the power at fuse or circuit box 1. Unscrew the two bolt nuts (D), remove the two rubber pads (E) and the crossbar unit (A) from the backplate. 2. Attach the crossbar unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the preinstalled fixture mounting screws if necessary. Note: Make sure that the fixture mounting screws are lined up horizontally to make the fixture level. 3. Pull out the source wires from the outlet box.
PAGE 3
The following parts are available for reorder if damaged or missing. Spare Parts List: Mounting Hardware 6805MM (1SET) Crossbar Unit (A) Mounting Screw (B) Wire Connector (C) Bolt Nut (D) Rubber Pad (E) A B C T0750 T0751 A: 9″ A: 9-3/4″ B: 10″ B: 12″ C: 11″ C: 13″ 5 Year Limited Warranty Vaxcel warrants all of our products against defects in workmanship and finishes for one year following the date of shipment.