Use and Care Manual

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Electrical Tape.
SAFETY INFORMATION
PREPARATION
ASSEMBLY INSTRUCTIONS
1
Please read and understand this entire manual before attempting to assemble, operate or install the product.
CAUTION
WARNING
Ground
Fixture
This lighting fixture is only suitable for a 12V power supply.
This LED lamp is a highly efficient, extremely low wattage, energy saving product.
Use shielded cable for outdoor use in the following sizes: 18 AWG, 16 AWG, 14 AWG, 12 AWG.
Do not submerge in water.
Do not repair or modify this product.
The maximum power of the LED module is 1.7W.
15.2 cm
Tube
Ground
Stake
Connector
Page 2 / 4
231122
12"(30cm)
10 ft. (3m)
GFCI
Transformer
4
Fixture installation
1. Secure the tube into the fixture, then
secure the ground stake into the tube.
Then gently insert the ground stake
into the ground.
Never push the fixture into the
ground by the fixture head.
Note: In compacted, clay, or
hard soils, moisten the ground
with water before inserting the
stake into the ground to avoid
breakage.
Fixture Assembly
Quick Connector
The connector is intended for use
with 18 AWG, 16 AWG, 14 AWG or
12 AWG outdoor cables.
2. Open the connector from the fixture wires and
insert the power cable from the transformer
(not included) into the connector. (Fig.2)
Contact Pin
Power Cable
2
3. Align the power cable with the contact
pins inside the connector and close
the connector (Fig.3), making sure the
contact pins pierce the power cable.
Contact Pin
Power Cable
3
Connector
4. To insure uniform brightness the first fixture should be
a minimum of 10 feet (3 meters) from the transformer
(not included). (Fig.4)
Connector
Connector