Installation Guide

W0112
Bolt Nut
Back Plate
Socket Ring
Glass Holder
Glass Shade
1. Thread two headless screws to the mounting plate, then
secure them with four lock nuts (Two on each side of the
mouting plate). Adjust the length of the headless screws
if necessary.
Note: Locate the two headless screws in horizontal line to ensure the fixture is in proper
position when the installation is done.
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire
connections using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding screw.
Then connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
4. Attach the back plate to the mounting plate by inserting the headless screws, then secure
it with two bolt nuts.
5. Attach the glass shade to the glass holder, then secure it with the socket ring.
6. Install a bulb (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
7. Turn on the power at the main fuse or circuit breaker box.
Mounting Screw
Fixture Wire
Lock Nut
Mounting Plate
House Grounding Wire
Fixture Grounding Wire
Green Grounding Screw
Wire Nut
Headless Screw
Outlet Box
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Bulb Type A Max.100W
(not included)
141114