Installation Guide

ManualsBrandsVaxcel ManualsShop All VaxcelVaxcel Lighting Jamestown 1 Light Wall Sconce

Back Plate

Ball Nut(G)

Glass Shade

Fixture

Rubber Pad

Ball Nut(-b)

Frame

Bulb Type A Max.100W

(not included)

Socket

1. Thread long screws through holes in mounting plate as shown,

then secure them with two lock nuts. Adjust the length of the long

screws if necessary.

Note: Make sure that the long screws are lined up horizontally, to

ensure that the fixture will be level.

2. Attach the mounting plate to outlet box using two mounting screws.

3. Pull out the source wires from the outlet box. Make wire connections

using wire nuts as follows:

---Connect the hot wire (usually black insulation) from the fixture to the

black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually bare wire) to the mounting plate with the green grounding screw. Then

connect it to the house grounding wire with a wire nut. If your outlet box does not have a house grounding wire, then

wrap the fixture grounding wire around the green grounding screw.

Carefully tuck the wires back into the outlet box.

Mounting Plate (A)

Mounting Screw (B)

Green Grounding

Screw (C)

Lock Nut (F)

Wire Nut (E)

Ball Nut (G)

141119

Page 1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0150

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Hardware Package (included):

Assembly Instructions:

Turn off the power at fuse or circuit box.

Mounting Screw (B)

Mounting Plate (A)

Green Grounding Screw (C)

Wire Nut (E)

House Grounding Wire

Long Screw(D)

Lock Nut(F)

Outlet Box

Fixture Wire

Fixture Grounding Wire

Long Screw(D)

Summary of content (2 pages)

PAGE 1
W0150 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Attach the back plate to the mounting plate: insert the long screws through the two holes, then secure it with two rubber pads and two ball nuts. CAUTION: With silicone caulking compound, caulk completely around where the back plate meets with the wall surface to prevent water from seeping into the outlet box. 5. Attach the glass shade and frame onto the fixture, secure them with ball nuts. 6. Install bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.