Installation Guide

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0349

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box

Installation Steps

190724

Headless Screw (D)Mounting Screw (B) Wire Connector (C)

Lock Nut (E)

Mounting plate (A) Ball Nut (F)

Ball Nut (F)

House Ground Wire

Green Ground Screw

Fixture Ground Wire

Mounting Screw (B)

Headless Screw (D)

Mounting Plate (A)

Outlet Box

Fixture Wire

Lock Nut (E)

Glass Shade

Glass Holder

Socket Ring

Type A Max.60 W

or ST Vintage Bulb

(not included)

Back Plate

Wire Connector (C)

1. Thread two headless screws (D) through the mounting plate (A),

then secure them with four lock nuts (E) (two on each side of the

mounting plate). Adjust the length of the headless screws (D) if

necessary.

Note: Make sure that the headless screws are lined up

horizontally, in order to ensure that the fixture will be

level.

2. Attach the mounting plate (A) to the outlet box by using two

mounting screws (B).

PAGE 1
W0349 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows: ---Connect the hot wire (black insulation) from the fixture to the black wire from the power source. ---Connect the neutral wire (white insulation) from the fixture to the white wire from the power source. ---Attach the fixture ground wire (green insulation or bare wire) to the mounting plate (A) with the green ground screw, then connect it to the house ground wire with the wire connectors (C).