Installation Guide

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Read and save these instructions.

191211

1. Remove the two set screws, separate the mounting plate unit (A) from the backplate.

2. Attach mounting plate unit (A) to the outlet box using two mounting screws (B).

3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:

---Connect the hot wire (black insulation) from the power source to the black wire from the fixture.

---Connect the neutral wire (white insulation) from the power source to the white wire from the fixture.

---Attach the fixture ground wire (green insulation or bare wire) to the mounting plate unit (A) with the

green ground screw, or connect to the source ground wire if available.

Carefully put the wires back into the outlet box.

Turn off the power at fuse or circuit box.

Installation Steps

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

W0355

Hardware Package (included):

Mounting Screw (B) Wire Connector (C) Set Screw (D)Mounting Plate Unit (A)

Wire Connector (C)

Green Ground Screw

Mounting Plate Unit (A)

Mounting Screw (B)

Backplate

Set Screw (D)

Socket Ring

Tube

Threaded Pipe

Fixture

Socket Fixer

Glass Shade

Socket

Fixture Ground Wire

House Ground Wire

Fixture Wire

Medium Base

Bulb Max.60W

(not included)

PAGE 1
W0355 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Read and save these instructions. Hardware Package (included): Mounting Plate Unit (A) Mounting Screw (B) Wire Connector (C) Medium Base Bulb Max.
PAGE 2
4. Attach the backplate to the mounting plate unit (A) by aligning holes, secure the two set screws from the side hole of the backplate into the side hole of the mounting plate unit (A). 5. Attach the tube to the fixture by threaded pipe. 6. Attach the glass shade onto the socket, then secure it with the socket ring using supplide socket fixer. 7. Install a bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage. Turn on the power at fuse or circuit box.