Installation Guide

171109
1. Carefully unpack the fixture, lay out the fixture on a clean surface.
2.
Attach the nipple to the mounting strap, then secure
it with a washer and hex nut.
3.
Attach the mounting strap to the outlet box by using
two mounting screws.
4.
Install the Fixture. (the Fixture is sold separately)
a.
Remove the canopy from the fixture before
installation (See Figure.
~ )
b.
Side fixture : Thread the fixture wire through the
canopy as showed, and then secure the fixture
to the canopy with metal pad, washer and hex nut.
5.Cut any excess fixture wires leaving only about 8"
(20cm) length from the top end of nipple, then
strip off 3/4"the fixture wires of plastic from each end.
6.
Pull out the outlet wires and house grounding wire
from the outlet box. Make wire connections using
the wire
---All black wires from rods to the black wire from
power source.
power source.
---All white wires from rods to the white wire from
---Attach the grounding wire to the mounting strap
with the green grounding screw.Then connect it to
the house grounding wire and all grounding wires
from the frame with a wire connector
Carefully put the wires back into the outlet box.
7. Attach the canopy to the mounting strap by inserting
the coupling, then secure it with the finial .
8. Angled mounting recommended for a vaulted or
angled ceiling. (See Figure. 4~6)
Support Brace
Canopy
Coupling Kit
Support Brace
Canopy
Cord Clamp
Canopy
Loop
Support Brace
A: 15-3/4"
B:1"
A
B
A: 11-3/4"
B:1"
A
B
Figure.6
Figure.5
Figure.4
Turn off the power at fuse or circuit box.
Installation Steps
(Y0005 / Y0006)
(Y0007 / Y0008)