User guide

VBOX 3iSL User Guide
Page 28 of 53
11/04/2012
VCI CAN input (Vehicle CAN Interface)
A VBOX 3iSL can log up to 16 user defined CAN bus signals on VCI port. Configuration is performed using the VCI Modules tab under Channels in VBOXTools
software setup window. CAN signal parameters can be entered manually by the user or imported directly from a CAN database (.DBC) file if available.
Racelogic supplies a free encrypted Vehicle CAN Databases, giving the user the ability to log basic CAN data from a large number of current vehicles from a broad
selection of manufacturers. Please visit the Racelogic website for more details.
CAN termination
A VBOX 3iSL contains an active termination between 0 Ohms and 120 Ohms, the active terminations are selectable via VBOXTools as shown above right.
NOTE: When the Usage of the CAN ports is swapped from one output socket to the other the Termination resistor setting does not follow. So you should
check that the Termination is correctly set for the output socket that you are then using.