Instruction manual

Getting Started
VBrick VOD-WM Server Admin Guide 9
Step 5. Configure the ETV Portal Server
The VOD-WM server must be configured in VBrick's ETV Portal Server before it is
recognized as part of the ETV system.
T To configure the VOD-WM server in ETV Portal Server:
1. Launch ETV Portal Server and login as an administrator.
2. Go to
Global Settings > Servers and select VOD-WM-STANDARD or VOD-WM-
ENTERPRISE
from the dropdown list.
3. Enter the IP or Domain, Server Description (optional), FTP User Name (default =
vbrickuser) and FTP Password (default = vbrickuser).
4. Accept the default
Publishing Point parameters and click Add when done.
This completes the Portal Server configuration. However in order to verify the installation as
explained below, you must manually sync up the VOD-WM server with the ETV Portal
Server as follows:
T To manually sync the VOD-WM server with the ETV Portal Server:
1. Launch the ETV Portal Server admin tool and go to
Global Settings > Global
Assignments > Assign VOD Polling Interval
.
2. Click
Sync Now. Do not change anything else and exit when done.
Step 6. Verify the Installation
Use the following sequence of steps to verify the VOD-WM server is installed properly and
can communicate with the ETV Portal Server. If you can use the ETV Portal Server to
launch a video stored on the VOD-WM Server, you have tested connectivity and verified the
installation. For more information about ETV Portal Server, see the ETV Portal Server
Admin Guide.