Specifications

C2-6104A OPERATION MANUAL
15
Status
message
Description Effect
No display There is no display attached
(HOTPLUG is low).
Nothing will be output on the DVI connector.
Unavailable The device attached is not
capable of supporting HDCP.
As the DVI output cannot be HDCP encrypted, then
a HDCP-encrypted source cannot be selected for
scaling.
Supported The device attached is
capable of HDCP, but the
output is not currently
encrypted.
As the DVI output is not HDCP encrypted, then a
HDCP-encrypted source cannot be selected for
scaling.
Active The device attached is
capable of HDCP, and the
output from the unit is
encrypted.
As the DVI output is HDCP encrypted, then a
HDCP-encrypted source can be selected for
scaling. Note that no other output connector (SDI,
CV, YC, YUV or RGBHV) will function – since they
are not encrypted.
Rep. supprt The repeater unit (e.g. scaler)
attached is capable of HDCP,
but the output is not currently
encrypted.
As the DVI output is not HDCP encrypted, then a
HDCP-encrypted source cannot be selected for
scaling.
Rep. active The repeater unit (e.g. scaler)
attached is capable of HDCP,
and the output from the unit is
encrypted.
As the DVI output is HDCP encrypted, then a
HDCP-encrypted source can be selected for
scaling. Note that no other output connector (SDI,
CV, YC, YUV or RGBHV) will function – since they
are not encrypted.
This menu may appear as either of the above – depending on whether the analog
and digital outputs are controlled separately.
This menu item allows you to select the type of signal output your unit will provide.
Types of output vary depending on the resolution selected and include various
types of component signals YUV or tlYUV (tri-level YUV) and the full range of RGB
type signals RGBHV, RGBS and RGsB (Sync on green).
Note that this value is remembered for each resolution – so you can set 1024x768
60Hz to RGBHV and 1280x720 60Hz to tlYUV and both will be remembered
separately. This value is not affected by a Factory reset – but is reset by a firmware
update.
This menu item is only available on certain units with an SDI output and when
locking to a CV or YC input. An internal de-jitter circuit ensures that the SDI output
has a low jitter over the full 10Hz to 100kHz range, even though the CV or YC input
may have a high jitter. However, this is not always compatible with a CV/YC output
where the colour sub-carrier should not be de-jittered and needs to follow a Lock
Adjust outputs
Anlog= [RGBHV] Dig= RGBHV
Adjust outputs
Output type [RGBHV]
Adjust outputs
Optimize for SDI [On]