Specifications

C2-6104A OPERATION MANUAL
35
This first adjustment controls the type of transition desired: ‘Cut’, ‘Fade’, ‘Wipe’ or
‘Push’.
If you select ‘Cut’ or ‘Fade’, the only remaining menu items will be ‘Switching Fade
Time’ and ‘Exit’. Selecting ‘Wipe’ or ‘Push’ exposes additional parameters.
This parameter controls how long a transition from one input to another takes. The
value can be 0 (a cut) or several minutes - adjustable in 1/10
th
second increments.
If you selected ‘Wipe’ or ‘Push’ for the transition type, then you will be able to
specify the ‘movement direction’ of the transition that you want. Both ‘Wipe’ and
‘Push’ support: Left to Right, Right to Left, Up/Down (Top to Bottom), Down/Up
(Bottom to Top). ‘Wipe’ also supports: Diagonal and Diamond effect.
Wipe Size sets the ‘granularity’ of the ‘Wipe’ effect and so is only shown when
‘Wipe’ is the transition type. The smaller the number, the more elements there are
to the wipe. To clarify by example, if you select the Diamond wipe effect and set a
small number into the Wipe Size parameter, you will have a large number of
Diamonds present in the transition. On the other hand, a large number loaded into
the parameter will result in only one or two diamonds being present during the
transition.
8.9 Adjust tally menu item
This menu only appears when a unit has an optional Tally / UMD module installed
inside it.
The Tally / UMD module allows the unit to respond to Tally / GPIO inputs in certain
ways (see below) and also allows under-monitor display (UMD) packets to be
received (using the TSL 3.1 protocol) and overwrite the source label text
automatically.
The UMD support menu item (‘UMD display address’) is listed under the ‘Adjust
sources’ menu section.
Adjust transitions
Transition [Fade]
Adjust transitions
Switching fade time [ .5]
Adjust transitions
Wipe type [Left -> Right]
Ad
just transitions
Wipe size [100]