Operation Manual

6
* Depending on version
INITIAL SETTINGS
It is possible to modify many of the set's initial settings according to your preferences.
• Enter the Initial Settings menu.
• Select one of the option you want to modify
• Alter the Choice.
• Leave the Initial Settings menu :
The set automatically leaves the Initialisation mode about 1 minute after your last operation.
Option Choice Usage
( or )( or )
TEMP * [NO, C, F] Select the desired temperature format (when a temperature
sensor is connected). 'NO' to disable function or 'C' (Celsius)
or 'F' (Fahrenheit).
SPD * [NO, KM/H, MPH] Select 'KM/H" or 'MPH' to activate speed warning (only
when connected and calibrated, see 'SDVC AND SPEED
WARNING' in 'INSTALLATION' and 'SPECIAL
FUNCTIONS').
SDVC * [OFF, 1, 2, 3, 4] Select the speed dependent volume control level (only when
connected and calibrated, see 'SDVC AND SPEED
WARNING' in 'INSTALLATION' and 'SPECIAL
FUNCTIONS').
TEL [NO, IN, MUTE] – Select 'NO' if no car phone is connected to the set.
– Select 'IN' if your phone provides a loudspeaker
connection.
– Select 'MUTE' to automatically interrupt the set's sound
output when using your car phone.
PHONE [LO, HI] Select 'LO' or 'HI' according to phone ('LO' in most cases).
LOGI [ON, OFF] Select 'ON' to limit the use of the set to one hour when
the car ignition is switched off.
LED [OFF, ON] Select 'OFF' to switch off the flashing warning light when the
front is removed.
LOUD [OFF, AUTO] Select 'AUTO' to activate dynamic loudness control.
BASS [80, 40] Select the frequency threshold of the low notes.
TREB [5K, 7K] Select the frequency threshold of the high notes.
AL [ON, OFF] Select 'ON' to activate automatic leveller between the
different sources.
BP_TYP [1, 2, 3, 4] Select type of confirmation beeps.
BEEP [1, 2, 3, 4, 5] Select volume level of confirmation beeps.
COMP [OFF, LOW, HI] Select the compression level for CD playback; 'LOW' to
retains the peaks in the volume; 'HI' to levels them out.