Operation Manual
14
* Depending on version
SAM (Software Access Mode)
It is possible to modify many of the set's default settings according to your preferences via 'SAM'.
• Press
to enter the 'SAM' menu.
• Press
or
to select one of the options in the menu you want to modify.
• Press or
to select the value/setting.
• Press to exit the 'SAM' menu.
The set automatically leaves this mode after 30 seconds if no key presses are made.
Option Value/Setting Usage
( or )(
or
)
TAVOL [1 to 31] Select volume level of Traffic Announcement, News bulletins
and Alarm messages.
START [1 to 31] – Select the start-up volume when power on.
– After modification of the start-up volume, if the set is
switched off and on within 10 minutes, the start-up volume
reverts to the last used volume setting.
– After modification of the start-up volume, if the set is
switched off and on after more than 10 minutes later, the
start-up volume is the level defined in 'SAM'.
MUTE [0 to 5] Select the mute level.
NAV* [OFF, LOW, HIGH] – Select 'OFF' if no navigation computer is connected to the
set.
– Select 'LOW' or 'HIGH' according to the navigation
computer's mute signal.
BEEP [0FF, 1, 2, 3, 4, 5] Select volume level of confirmation beeps.
SDVC * [OFF, 1, 2, 3, 4] Select the SDVC (Speed Dependent Volume Control)
compensation volume level (only when connected and
calibrated, see 'SDVC' in 'INSTALLATION' (page 5) and
'SPECIAL FUNCTIONS' (page 13)).
Level 1 gives a smaller increase while level 4 gives gives a
greater increase with respect to the car's speed.
TEL/ [TEL OFF, MUTE HI, – Select 'TEL OFF' if no car phone is connected to
HFREE MUTE LO, HFREE LO the set.
HFREE HI] – Select 'MUTE LO' or 'MUTE HI' (according to phone type)
to automatically interrupt the set's sound output when
using your car phone.
– Select 'HFREE LO' or 'HFREE HI' (according to phone
type) if your phone provides a loudspeaker connection.
CLK [ON, OFF] Select 'ON' to activate CLOCK feature.
CLOCK [RDSCLOCK, Select 'RDSCLOCK' to activate RDS clock or "MANCLOCK'
MANCLOCK] to set clock manually.
[CLOCKSET] If 'MANCLOCK' selected; set the time. to adjust the hour
digit,
to adjust the minute digit.
[12HCLOCK, Select desired clock format.
24HCLOCK]
004-16 Mid_Eng 8/15/02, 6:48 PM14