Operation Manual

14
* Depending on version
SAM (Software Access Mode)
It is possible to modify many of the set's default settings according to your preferences via 'SAM'.
Press
to enter the 'SAM' menu.
Press
or
to select one of the options in the menu you want to modify.
Press or
to select the value/setting.
Press to exit the 'SAM' menu.
The set automatically leaves this mode after 30 seconds if no key presses are made.
Option Value/Setting Usage
( or )(
or
)
TAVOL [1 to 31] Select volume level of Traffic Announcement, News bulletins
and Alarm messages.
START [1 to 31] – Select the start-up volume when power on.
After modification of the start-up volume, if the set is
switched off and on within 10 minutes, the start-up volume
reverts to the last used volume setting.
After modification of the start-up volume, if the set is
switched off and on after more than 10 minutes later, the
start-up volume is the level defined in 'SAM'.
MUTE [0 to 5] Select the mute level.
NAV* [OFF, LOW, HIGH] Select 'OFF' if no navigation computer is connected to the
set.
Select 'LOW' or 'HIGH' according to the navigation
computer's mute signal.
BEEP [0FF, 1, 2, 3, 4, 5] Select volume level of confirmation beeps.
SDVC * [OFF, 1, 2, 3, 4] Select the SDVC (Speed Dependent Volume Control)
compensation volume level (only when connected and
calibrated, see 'SDVC' in 'INSTALLATION' (page 5) and
'SPECIAL FUNCTIONS' (page 13)).
Level 1 gives a smaller increase while level 4 gives gives a
greater increase with respect to the car's speed.
TEL/ [TEL OFF, MUTE HI, Select 'TEL OFF' if no car phone is connected to
HFREE MUTE LO, HFREE LO the set.
HFREE HI] Select 'MUTE LO' or 'MUTE HI' (according to phone type)
to automatically interrupt the set's sound output when
using your car phone.
Select 'HFREE LO' or 'HFREE HI' (according to phone
type) if your phone provides a loudspeaker connection.
CLK [ON, OFF] Select 'ON' to activate CLOCK feature.
CLOCK [RDSCLOCK, Select 'RDSCLOCK' to activate RDS clock or "MANCLOCK'
MANCLOCK] to set clock manually.
[CLOCKSET] If 'MANCLOCK' selected; set the time. to adjust the hour
digit,
to adjust the minute digit.
[12HCLOCK, Select desired clock format.
24HCLOCK]
004-16 Mid_Eng 8/15/02, 6:48 PM14