Owner`s manual

Taking safety precautions and installation, Fig. 3

Before starting work, disconnect the earth cable from the negative terminal of the vehicle

battery in order to prevent short circuits. At the same time, follow the vehicle manufacturer's

safety instructions (alarm system, airbag, immobiliser, radio coding etc.).

The CIX 3000 Blue must on no account be installed in the following locations:

❏

Near electric motors or other aggregates of the vehicle electrical system.

❏

Near wiring harnesses of the vehicle electrical / electronic system.

❏

At locations where it is exposed to high temperatures or direct sunlight.

❏

At locations with excessive humidity, spray water or dirt.

❏

In locations that are electrically isolated (e.g. beneath/behind sheet metal parts, in the

luggage compartment).

Accessibility of the system bus slots (“Expansion Module”) and other connectors for

subsequent retrofitting or conversion should also be taken into account when selecting

the installation location.

Installation

The CIX 3000 Blue can be secured in a suitable installation location, using the screws

supplied with the unit. four fastening tabs are provided on the housing of the CIX 3000 Blue

for this purpose.

Electrical connections

Route all wiring with care. For wiring details, refer to the connection diagram and to the

following table.

1. CIX 3000 Blue as a standalone solution (without the CI 3000), Fig. 4a

■ “Power/Audio” power supply cable

Cable colour Connection

Red + 12 V permanent positive (must be rated for at least 2 A.)

Purple + 12 V ignition positive

Brown Battery negative (body)

White/brown Mute

Green Audio output loudspeaker +

Green/black Audio output loudspeaker –

Only connect electrical signals to suitable connecting points in the vehicle.

For direct connection of permanent positive (red lead) to the battery, the fuse must be no

further than 10 - 15 cm from the positive terminal of the battery. If it is necessary to extend the

positive lead, an additional 10 A fuse must be provided close to the battery (max. distance

10 - 15 cm). Failure to do so may result in a wiring fire hazard.

INSTALLATION INSTRUCTIONS

English