User manual

Operation
127
English
Operation
All of the settings that you make on the system are stored after it is switched off.
Control elements
The control elements of the Multimedia System are shown on page 3.
The control elements have the following functions:
Remote control
ALT-R: Plan Alternative Route
REP: Invoke current audible directional information and,
if applicable, repeat traffic reports (for TMC reception only)
Cursor buttons and OK- / confirmation button
Adjust volume of audible messages
Invoke Start Menu (reset to navigation  only in connection with
Multimediabox, see System enhancements on page 164)
Change directional guidance displays and / or switch between menus
and directional guidance displays (only for certain menus)
Press the two side buttons on the holder in order to remove the remote control.
A
Push the remote control into the holder until it engages for storage and
prior to
travel.
The buttons of the remote control are lit up for a short time when pressed.
The buttons are always lit in the holder when the ignition is switched on.

The batteries of the remote control must be changed if you use the remote con-
trol outside of the holder and the navigation system no longer responds at the touch
of a button or the battery symbol
(
appears in the status line of the monitor (at the
bottom edge of the screen).
In order to be able to continue to operate the system push the remote control device
into the holder; the internal batteries are not needed.
Battery change, see Changing batteries for remote control on page 171.
DE-IT-E_MO_MS5000.book Page 127 Sunday, November 7, 1999 10:57 PM