Specifications

02/11
INSTALLATION INSTRUCTIONS: Viewline 85 mm
TU00-0752-5807102
1-10
5
Technische Änderungen vorbehalten - Technical details subject to change
TU00-0752-5807102
Tachometer
Reconnect the battery after inspecting the connection.
If necessary, replace the main circuit switch. Turn on the ignition
and conduct a functional test. Reprogram other instruments that
may have lost their saved settings.
Align the instrument and hand-tighten the fastening
nut. Ensure that the nut is not tightened with a torque
greater than 400 Ncm.
* Make sure the seal lays flat between the panel and
the front ring.
If you would like to omit the fastening nut, you may
use the part set A2C59510854 as an alternative.
This is recommended if the installation location is
subject to vibratory loads.
Screw the stud bolts into the provided drill holes in
the enclosure. Max. stud bolt torque is 1.5 Nm
Place the bracket on the stud bolt and hand-tighten
the knurled nut.
* Make sure the seal lays flat between the panel and
the front ring (see Fig. 14).
• Please note that when you disconnect the battery, all volatile
electronic memories lose their input values and must be repro-
grammed.
14
15
16
17
18
*
GB