Operation Manual

X3DW VDO CYCLECOMPUTING12
GB SLO PL JP
JP PL SLO GB
www.vdocyclecomputing.com X3DW 13
4.6 Transmitter pairing
The speed and cadence signals (Option: Item no.
7702) will be transmitted digitally and encoded to
your computer. This technology is less prone to
problems than analogue transmission. This way,
when riding in a group there are no data overlaps
(cross talk). So that the computer acquires the
digital encodings from the transmitter, a pairing
must be made:
step 1 Place the computer into the handlebar
holder. The display for the speed and the cadence
now flashes. The flashing shows that the computer
is looking for its transmitter.
step 2 Spin the front wheel or simply set off and
the computer acquires the digital encodings.
When the computer has found the transmitters
and has acquired the encodings (pairing), the
speed and cadence are shown on the display.
ATTENTION: The time window for pairing is
5 minutes. If you do not start cycling during these
5 minutes, no pairing takes place. Speed and
cadence are not displayed. The pairing
then has to be repeated:
B
Place the computer back into the handlebar
holder OR
B
press the buttons
C
+
M
together.
5. Basic settings
5.1 Setting the language
5.2 Setting and measuring the wheel size
5.2.1 Setting using tyre table
Using the buttons, go to
SETTINGS/SELECT.
Confirm with
M
.
You are now in setting mode
(pressing
C
for 3 seconds gets
you back to function mode).
to LANGUAGE SELECT.
Confirm with
M
.
You must set the wheel size (wheel roll circum-
ference) of your bike so that your VDO computer
can measure correctly. There are 2 ways of
doing this:
The common types of tyres are listed in the tyre
table. If your tyre type is not listed, we recommend
entering the wheel size manually.
The values given in the table are approximate
values. These values differ according to brand, tyre
height and tyre profile. This can consequently also
lead to discrepancies in the distance measured
and the speed shown.
to LANGUAGE ENGLISH.
Confirm with
M
.
ENGLISH SELECT OK? Confirm with
M
.
LANGUAGE SELECT DONE. The computer automati-
cally returns to the start menu SETTINGS/SELECT.
mm-value inch-value
16 x 1,75 1272 50,1
20 x 1,75 1590 62,6
24 x 1 ⅜ 1948 76,7
24 x 1,75 1907 75,1
26 x 1 1973 77,7
26 x 1,5 2026 79,8
26 x 1,6 2051 80,7
26 x 1,75 2070 81,5
26 x 1,9 2089 82,2
26 x 2,00 2114 83,2
26 x 2,125 2133 84,0
26 x 1 ⅜ 2105 82,9
26 x ¾ 1954 76,9
27 x 1 ¼ 2199 86,6
28 x 1,5 2224 87,6
28 x 1,75 2268 89,3
28 x 1 ½ 2265 89,2
28 x 1 ⅜ 2205 86,8
30-622 2149 84,6
32-622 2174 85,6
37-622 2205 86,8
40-622 2224 87,6