User's Manual

AMG1000BHx HD Truck Kit Installation Guide 13
9.0 Safety & Regulatory Information
Document Conventions
This document uses the following special formats to emphasize key information. Be aware of
all warnings and cautions before you begin to use AMG1000BHx.
Safety Precautions
Read and follow the following safety instructions before installing or operating an
AMG1000BHx kit.
WARNING! Whenever you see this icon and heading, the associated text addresses or discusses a
critical safety or regulatory issue.
CAUTION: Whenever you see this icon and heading, the associated text discusses an issue which
could result in damage or abuse of the equipment. Carefully read and follow these instructions.
WARNING! Before installing or operating this equipment, read all safety, installation and operating
sections. Follow all instructions - failure to do so may result in damage to the unit or severe personal
injury. Retain this manual for future reference.
Avant d'installer ou d'opérer cet équipement, lisez, toutes les sections de sécurités, d'installations et
d'opérations. Gardez ce manuel comme source de référence. Suivez toutes instructions - si non, vous
risquez d'endommager la machine ou de vous blesser sérieusement.
WARNING! Servicing should not be attempted by the user. There are no user serviceable parts
inside. Refer all servicing to factory qualified personnel.
N'essayez, pas de réparer cet équipement vous même. Référez toutes revisions nécessaire au personnel
qualifié de la manufacture.
WARNING! Cleaning - Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.
Le nettoyage - n'utilisez pas de nettoyeurs aérosols ou liquides. Utilisez un tissu humide pour nettoyer.
WARNING! Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. ESD
damage occurs when electronic components are improperly handled and can result in complete or
intermittent failures. Always follow ESD-prevention procedures when you are working on an AMG base
unit or antenna. Ensure that the unit is electrically connected to an earth ground and wear a properly
grounded ESD-preventive wrist strap. If no wrist strap is available, ground yourself by touching the
metal part of the unit.
WARNING! The installation of your AMG device must comply with vehicle wiring standards and best
practices.
WARNING! Fuse-handling equipment must be used to remove or install fuses and shunts when the
terminals are energized. The tool must be insulated for the circuit voltage.
WARNING! Disconnect all power before installing or removing a chassis. Never assume that power
is disconnected from a circuit. Always check.
Note: Keep the chassis area clear and dust-free during and after installation.