User's Manual

14 AMG1000BHx HD Truck Kit Installation Guide
Regulatory Notices
Federal Communications Commission (FCC) Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may
cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
occupational/controlled environment
The antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 8” (20cm) from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
This transmitter is approved for use with the antennas supplied with this equipment.
Maximum Antenna gains (including cable loss) are:
AMG1021B Backpack Antenna: +1.6dBi (GSM 850) and +2.9dBi (PCS1900).
AMG1021A External Antenna: -1.0dBi (GSM 850) and -1.7dBi (PCS1900).
Use of different antennas is not permitted. Failure to comply will invalidate FCC rule
compliance.
Industry Canada Compliance
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
• This device may not cause interference, and
• This device must accept any interference, including interference that may cause
undesired operation of the device.
This device has been designed to comply with safety requirements for exposure to radio
waves (SAR) in accordance with RSS-102. This device should be installed and operated with
minimum distance 20cm between the equipment and your body.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
• L'appareil ne doit pas produire de brouillage, et
• L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
Note: Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
CAUTION: To comply with Industry Canada RF exposure requirements, a minimum separation
distance of 8 inches (20 centimeters) is required between this antenna and all persons.
Pour conformer aux conditions d’exposition RF d’Industry Canada, une distance minimum de séparation
de 20 centimètres est exigée entre l’antenne et toutes personnes.
WARNING! Changes or modifications not expressly approved by Vecima Networks Inc. could void
the user’s authority to operate the equipment.