User's Manual

AMG1000BHx HD Truck Kit Installation Guide 7
2) Locate the vehicle's Deutsch 9 pin connector (normally located on drivers left side under
steering wheel and may be covered by a protective cap).
Figure 9: Deutsch 9-pin Connector Location
3) Remove the Deutsch 9-pin connector from the panel to access the wiring.
Figure 10: Removed Deutsch 9 Pin Connector & Relevant Pins
4) Remove the pins designated A, B, C, and D from the Deutsch 9-pin connector on the
truck using a Deutsch pin extractor (Deutsch Part Number: 0411-310-1605).
5) On the AMG wiring harness, locate the 4 wires with pre-installed pins as shown in Figure
11. Connect these wires to the A, B, C, and D slots of the vehicle's Deutsch 9-pin
connector as described in Table 1 and shown in Figure 11.
Figure 11: Wiring Harness to CAN J1939 Bus Wiring Configuration
Note: As each pin is removed, label each wire with its specific connection type (i.e. CAN_L,
CAN_H, VBATT, GND) for later reference, if the colors are not easily identified. Use Figure
1-10 above as a reference.
A
B
C
D
E
F
G
H
J
CAN_L (Green)
CAN_H (Yellow)
VBATT (Red)
GND (Black)
C
A
V
B
A
c
k
)
Pin Extractor
Deutsch PN: 0411-310-1605
A
B
C
D
E
F
G
H
J
CAN_L (Green)
CAN_H (Yellow)
VBATT (Red)
GND (Black)
C
AN
_
CAN_H
(Y
V
BATT
(
Re
d