User's Manual

AMG1000BHx HD Truck Kit Installation Guide 9
8) Once all the pins are in, insert the Green wedge lock into the center of the Deutsch 4-pin
receptacle using needlenose pliers until it locks in place. Ensure that the pins have been
inserted deep enough into the 4 pin receptacle so that no part of the pins are exposed
on the back and that the pins protrude above the wedge lock as shown in Figure 14.
Figure 14: Deutsch 4-pin Receptacle with Wedge Lock
9) Connect the Deutsch 4-pin plug housing on the wiring harness to the receptacle
housing.
Figure 15: Deutsch 4-pin Receptacle and Housing
10)Connect the Ignition Sensor (Brown), Parking Brake (Orange) and Ground
(Black) wires from the Molex 8-pin connector (see Figure 7) accordingly.
11)Replace the diagnostics fuse that was removed earlier. Check all wiring connections to
ensure that they have been made correctly.
Note: If the four wires that extend from the Molex 8-pin connector wires are not to be connected at
this time, make sure they are cable tied and out of the way.
CAUTION: The Ignition Sensor and Parking Brake wires on the vehicle may be live. Take appropriate
measures such as removing the applicable fuse(s) or disconnecting the vehicle battery before
connecting these sensors to the AMG.
Note: The 1-Wire (Blue) wire is not used and should be capped off to prevent making electrical
contact.