User Manual

VCom Inc.
AP5857 Manual; ml_ap5857_08 (Oct 2005)
Approved: R.B.
28
To load the factory defaults, “6”. The local interface prompt will change to:
Load Factory Defaults [Y/N}(N)>_
Enter Y to load factory defaults or press ENTER to select No.
Antenna Gain
The antenna gain line shows the current antenna gain. It is factory set to 12 dBi for the internal antenna and
32.4 dBi for the point-to-point antenna. These values reflect the effective gain and include cable and radome
loss. The gain cannot be set by the user.
5.6.6 Ethernet Settings
The Ethernet Settings Menu provides access to the Ethernet settings and options. To access this menu from
the Main Menu, type “6” to display the Ethernet Settings Menu.
Figure 5.10 Ethernet Settings Menu
*** VCom Inc. AP5857 Ethernet Settings ***
MAC Address 00:20:4A:52:3A:34
1)IP Address 10.10.10.11
2)Netmask 255.255.255.0
3)Gateway IP Address 10.10.10.10
4)Renew Ethernet Interface
5)SNMP Enable Enabled
6)SNMP Manager IP Address 10.10.10.10
7)SNMP Read Community public
8)SNMP Write Community private
X)Exit
ENTER)Refresh
Select>_
MAC Address
This address is unique for each unit and consists of 6 two digit hexadecimal values.
IP Address
The IP address must be set to a unique value in your network. Refer to Section 4 if you are not familiar with
IP addresses. If set to 0.0.0.0, DHCP mode is automatically enabled.
Provided a DHCP server exists on
the network, it will provide the unit with an IP address, gateway address, and subnet mask when
the unit boots up.
To change the IP address, type “1”. The local interface prompt will change to:
IP Address [] (10.10.10.11)>_
Enter the new IP address or press ENTER to use the current value.