User's Manual
Table Of Contents
- Copyright
- Software License Agreement
- Warranty
- Contents
- Figures
- Tables
- Preface
- 1 Introduction
- 2 MDB1000
- 3 Setup Menu
- 4 Installation
- Appendix A Factory Configuration
- Appendix B Ethernet Cables and Connectors
- Index
24 APCD-LM048-1.3
4: Installation
• PoE Lighting Arrestor - if mounted outdoors and/or required by local or national
electrical codes. The protector must be able to protect all 8 conductors and must be
able to pass the DC power as well as the data.
• Straight-through Outdoor Rated Ethernet cable(s) - needed to connect the EUM3006
to the Lightning Arrestor or PoE Inector or other lengths of Ethernet cable.
• Ethernet cable from PoE Injector - needed to connect to the end-user’s computer or
switch or router. If the end-user’s computer is connected directly to the PoE injector,
then this must be a cross-over Ethernet cable.
• Tools to bolt the mounting plate to the modem using the 9/16” hex head bolts and to
tighten the gear clamps with either a slot screw driver or 3/8” socket or wrench.
Other useful tools include:
• The MDB1000 makes installation and alignment much easier, avoiding the need for a
PC or PDA. This makes installation a one-person operation.
• Extension cord for the PoE injector (or battery operated PoE Injector, if available) -
This allows you to take the PoE injector along with the modem and apply power when
on a roof or up a ladder. Note that PoE Injector is an indoor unit, so do not use in
inclement weather.
• If custom Ethernet cables are made on-site, then an Ethernet connector crimping tool
is required.
• If it is necessary to splice Ethernet cables outdoors, then the splice must be weather-
proofed, so the appropriate tape and/or outdoor junction boxes are needed.
Useful information includes:
• Direction from the installation site to the CCU.
• Expected signal strength for the installation site based on the network operator’s site
survey or signal strength for other installations in the vicinity.
• The IP address of a site that accepts pings as well as the name of a site that accepts
pings, for testing the data link
4.2.3 Verifying the EUM3006 Components
Verify that the EUM3006 kit is complete with:
• EUM3006 modem with integrated antenna
• Attaching plate with 4 bolts and lock washers
• 2 Gear Clamps
• Mating connector for the weatherproof housing around the Ethernet plug and jack
• AC/DC PoE power supply
• AC power cable
4.2.4 End-Users PC
Ensure that the end-user PC is equipped with an Ethernet interface.