User's Manual Part 1

APCD-LM043-8.0 (DRAFT C) 111
7 Configuring the CCU
This section explains the following procedures and topics:
•
CCU and EUM Serial Number, MAC Address, and Station ID on page 112
•
Setting the CCU Password on page 112
•
Configuring the CCU RF Parameters on page 113
•
Configuring CCU Protocol Modes and IP Addresses on page 114
•
Configuring DHCP Relay on page 118
•
Configuring Port Filtering on page 119
•
Configuring the SNTP/UTC Time Clock on page 120
•
Configuring SNMP on page 124
•
Adding EUMs to the Authorization Table on page 125
•
Configuring RADIUS on page 126
Before you configure the CCU
• Familiarize yourself with the CLI commands, syntax and shortcuts, outlined in
Appendix C on page 189. This appendix provides a complete list of the available CCU
commands, some of which are not discussed in this section.
• Connect a PC to the CCU directly to the console port, or through a Telnet session.
See
Command-line Interface on page 91 for console settings.
CAUTION: Remember to regularly enter save or commit and
press
Enter, to save your configuration changes to the file system.
As well, some parameters and configuration files (refer to Table
17 on page 108 for details) do not take effect until you reboot the
unit, specifically the RF frequency, transmit power, and IP
addressing.