User's Manual Part 1

114 APCD-LM043-8.0 (DRAFT C)
7: Configuring the CCU
The following example
• Sets the CCU operating frequency to 917 MHz,
• Sets the transmit power level to
high,
NOTE: Changes to the transmit power level take effect immediately, they
do not require a CCU reboot.
• Saves the new settings,
• Reboots the CCU so that the new parameters take effect, and
• Displays the CCU RF parameters.
60:03:3a> radio frequency 9170
Radio Frequency: 9170
60:03:3a> radio rf high
RF Power: HIGH
60:03:3a> save
Basic Config saved
Port Filter Config saved
sntp cfg file saved
Route Config saved
Authorization Database saved
DHCP Server Config saved
60:03:3a> reset
rebooting CCU ...
(... Power On Self Test ...)
WaveRider Communications, Inc. LMS3000
Password:
60:03:3a> radio
RF Power: HIGH
Radio Frequency: 9170
60:03:3a>
7.4 Configuring CCU Protocol Modes and IP Addresses
This section explains how to configure the CCU to use Routed, Switched Ethernet, or Through
Only mode.
In previous software versions, all systems used Routed mode. In Routed mode, all EUMs and
end-user computers have the CCU radio IP address as their gateway. If you wish to convert a
system from Routed mode to Switched Ethernet or Through Only mode, it may be simpler to
assign that IP address to the new gateway router port, rather than changing the gateway IP
address on all the EUMs as associated end-user computers. The reverse applies to changing
from Switched Ethernet or Through Only mode to Routed mode.
In
IP Network Planning on page 59, you determined the following:
• CCU Protocol Mode
• CCU gateway IP address