User's Manual Part 1

136 APCD-LM043-8.0 (DRAFT C)
8: Configuring the EUM
3. At the Enter New Password prompt, type the new password.
TIP: Passwords are alphanumeric and case-sensitive. For
example, “abc” is not the same as “aBc”.
4. At the
Verify password prompt, type the new password again.
The system displays a message that your password has been successfully changed.
60:ff:fe> password
Enter Current Password: ********
Enter New Password: ********
Verify password: ********
Saving new password
Password Changed
60:ff:fe>
CAUTION: Remember to record the password. Unlocking the
EUM can only be performed by contacting WaveRider Technical
Support.
8.2 Configuring the EUM RF Parameters
To Set the EUM Operating Frequency
1. Type radio frequency <frequency> and press Enter.
• <frequency> is the EUM operating frequency in tenths of a MHz. For
example, 917.0 MHz is entered as
9170.
2. Type
save or commit and press Enter.
3. Before the new radio frequency will take effect, you must reboot the EUM by typing
reset and pressing Enter.
To Set the EUM Power Level
1. Type radio rf <power level> and press Enter. <power level> is the EUM
transmit power level, either:
• the desired power level, in dBm, any integer value in the range 15 - 26
inclusive,
•
high (+26 dBm), or
•
low (+15 dBm).
For example,
radio rf 22 will set the RF output power to +22 dBm.
NOTE: Use the HIGH power level unless your site has unique
requirements for which a numerically set power level, or the LOW
power level, is more appropriate. For example, the capability to