User's Manual Part 1

APCD-LM043-8.0 (DRAFT C) 5
2 Quick Startup
This section outlines the procedure for setting up a very simple LMS4000 900 MHz radio
network consisting of one CCU and one EUM. This simple network, which can be set up in a
lab environment, helps you become familiar with basic LMS4000 configuration and operation.
As you become more confident and are ready to progress to customer installations,
WaveRider recommends reading the other sections in the manual.
Quick Startup uses static IP addresses for the purpose of simplicity, even though the CCU and
EUM support DHCP relay.
2.1 Equipment
As a minimum, the Quick Startup requires the following equipment:
one CCU kit, consisting of
• CCU
• CCU power supply and cable
• CCU setup antenna
one EUM kit, consisting of
•EUM
• EUM power supply and cable
• 3m CAT5 crossover Ethernet cable with ferrite bead
one PC, equipped with terminal emulation software such as HyperTerminal and an
Ethernet network interface card
one WaveRider indoor antenna, complete with mounting bracket and RF cable
one Straight-through RS-232 serial cable, DB-9 male to DB-9 female