User's Manual Part 1

6 APCD-LM043-8.0 (DRAFT C)
2: Quick Startup
2.2 Quick Startup Network
Figure 1 shows the IP addressing scheme for the quick startup network described in this
chapter.
Figure 1 Quick Startup Network
2.3 Equipment Setup
Remove the equipment from the boxes and set up the physical configuration shown in Figure
2. The CCU is configured in Switched Ethernet mode with a gateway router being the gateway
for the CCU, EUM, and subscriber PC. Use this setup procedure to configure the CCU, while
keeping the following points in mind:
• Maintain the order of installation shown in Figure 2.
• Maintain at least 15 feet (4.5 meters) of physical separation between CCUs and
EUMs.
192.168.10.2 /24
192.168.10.250 /24
Gateway Router
192.168.10.1 /24
CCU
Switched
The EUM
Ethernet IP
address is
conf igured.
Subscriber
Computer
192.168.10.251 /24