User's Manual Part 2

208 APCD-LM043-8.0 (DRAFT C)
Appendix C: Command-Line Syntax
radio frequency <frequency> Changes the EUM radio frequency.
•
<frequency> is the new radio
frequency, in tenths of a MHz. (For
example, 905.0 MHz is entered as
9050.) The radio frequency must be
within the range of 9050 to 9250. The
frequency may use only 0.2 MHz
increments and may use even values
only.
√
radio rc Clears the RSSI, SQ, RNA, and RNB
histograms.
radio rf high|low|<value> Displays or sets the power of the EUM
radio, where programming the value to:
•
high will set the transmit power
output to +26 dBm,
•
low will set the transmit power to
+15 dBm, and
•
<value>, where <value>, an
integer between 15 and 26
inclusive, will set the transmit power
to
+<value> dBm.
NOTE: The EUM RF level should normally
be set to
high.
radio rh Displays the RSSI, SQ, RNA, and RNB
histograms.
radio rssi Displays continuous RSSI readings. Press
any key to halt.
reset|reboot Reboots the EUM.
route Displays the routing table for the EUM.
route stats Displays the routing statistics.
save|commit Saves configuration changes.
snmp Displays the EUM SNMP information.
snmp community Displays the SNMP communities.
snmp community add <community>
<read|write>
Adds an SNMP community.
•
<community> is the name of the
SNMP community being added, from 1-
31 characters in length.
• Enter
<read> or <write> to indicate
the type of the community being added.
Command Syntax (EUM) Command Description