User Manual
Table Of Contents
- Copyright
- Software License Agreement
- Warranty
- Contents
- Figures
- Tables
- Preface
- 1 Introduction
- 2 MDB1000
- 3 Setup Menu
- 4 Installation
- Appendix A Factory Configuration
- Appendix B Ethernet Cables and Connectors
- Appendix C Acronyms and Abbreviations
- Index
30 APCD-LM048-1.1
4: Installation
The PoE Injector must be located indoors as it is not rated for outdoor conditions. Therefore
the Ethernet cable must enter the building in an appropriate location, preferably near the
lightning arrestor.
4.3.4 Provide Power to the EUM3006
An indoor PoE Injector, shown in Figure 7, is provided with every EUM3006. Locate it in a
convenient location that has access to an AC plug and the Ethernet cable that runs to the
EUM3006. If a Lightning Arrestor is used, the PoE Injector must be located on the protected
side of the lightning arrestor.
Plug the Ethernet cable to the modem into the port marked “J1 DATA & PWR.
Figure 7 PoE Injector - Data & PWR and Data Ports
Alternatives to the PoE Injector provided can be used, such as PoE enabled routers or
switches. If these provide 48 VDC 802.3af Mode B PoE power, then the EUM3006 can be
connected directly to them.
CAUTION: Failure to use an acceptable PoE power supply may
damage the EUM3006 and void the warranty.