User Guide

Connecting Kit Components
8 APCD-LM013-D
To Connect the EUM3000 Components
1. Hand-screw the antenna cable onto the corresponding
connector at the back of the EUM3000 (refer to pointer 1 in
Figure 2). Do not use wrenches or pliers. Do not cross-thread
or overtighten.
2. If you are connecting the EUM3000 directly to your computer,
attach the crossover Ethernet cable that is included with your
kit to the Ethernet port on your computer and the Ethernet port
on the EUM3000 (refer to pointer 2 in Figure 2). If you are
connecting the EUM to your computer through a hub, use the
Ethernet cable recommended by the hub manufacturer.
3. Connect the DC converter to the EUM3000. To do this, press
firmly at the base of the DC connector on the power cord, and
attach to the corresponding DC connector on the EUM3000
(Figure 3).
Figure 3 Connect the DC Power Cord to the EUM3000
Press firmly at the base of
the DC connector
EUM