User's Manual Part 1
Table Of Contents
obr3650_ml_01_sd Approved: C.W.
2-5
Once the OBR3650 is mounted to the pole, the Elevation Angle may be adjusted as necessary and the unit may be
connected to the network via a CAT5E cable with a standard RJ45 connector on one end and a special Molex®
backshell with RJ45 connector on the other end.
NOTE
If not using a pre-made cable assembly (such as a CAT5CABLE/OD/25, CAT5CABLE/OD/50, CAT5CABLE/
OD/75 or CAT5CABLE/OD/10 from Vecima Networks), then a cable assembly will have to made using the
Molex® backshell included with the OBR3650. Please see Appendix 1 for details on how to install the Molex®
backshell.
Figure 2-5 Connecting the OBR3650 to the Network
µWRµ
7RFRQQHFWWKH(WKHUQHWFDEOHLQVHUW
DQGWZLVWFORFNZLVHWRORFNLQWRSODFH
&RQQHFWWKHRWKHUHQGRIWKH(WKHUQHWFDEOH
LQWRWKHQHWZRUNYLDVXUJHVXSSUHVVRU
7RDGMXVWWKHHOHYDWLRQDQJOHRI
WKH2%5ORRVHQWKHVHIRXU
VFUHZVDQGWLJKWHQZKHQWKH
GHVLUHGDQJOHLVDFKLHYHG