User's Manual Part 1

obr3650_ml_01_sdApproved: C.W.
ii
Regulatory Notices
FCC Compliance
This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures.
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
Industry Canada Compliance
Operation of this device is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
The users should not modify or change this device without written approval from Vecima Networks. Modification will void
warranty and authority to use the device.
For safety reasons, people should not work in a situation where RF exposure limits could be exceeded. To prevent this
situation, the users should consider the following rules:
• Install the antenna so that there is a minimum of 23 cm (9.06 in) of distance between the antenna and people.
• Do not turn on power to the device while installing the antenna.
• Do not connect the antenna while the device is in operation.
• Do not collocate or operate the antenna used with the device in conjunction with any other antenna or transmitter.
• In order to ensure compliance with local regulations, the installer MUST enter the antenna gain at the time of
installation.
Any changes or modification to said product not expressly approved by Vecima Networks voids the user's authority to
operate this device.
The Vecima OBR3650 base station unit must be installed by a trained professional, value added reseller, or systems
integrator who is familiar with RF cell planning issues and the regulatory limits defined by Industry Canada for RF
exposure.