User's Manual

tri2525b_ml_03_sd Approved: G.V. 14
Vecima Networks Inc.
2.4 Waterproofing Connections
This will provide moisture protection and keep the connections tight. Vecima Networks has provided a
6-inch length of rubber self-amalgamating sealing tape to use on the TRI2525B F-connector.
Step 1
Use a 6” section of rubber sealing tape. Starting at the TRI2525B end, stretch the tape and wrap it
around the connector as close as possible to the wall of the TRI2525B. Overlap the tape by
approximately one-half of its width so that it can form a seal with itself. Extend the wrapping to
approximately one-inch past the end of the connector.
Step 2
Cover the sealing tape with electrical tape (not provided). Start approximately one inch further down the
cable, and stretch the tape, overlapping by one-half. Wrap to the TRI2525B end and without breaking
the tape, wrap back down to the cable end.