Installation Manual

HW Installation manual Rev 3.10
VECOS Europe BV, Esp 237, 5633 AD EINDHOVEN, The Netherlands Page 15 of 19
7. V3/V3+ Default LED states
The Status LED of the V3/V3+ locks can be configured in Releezme to all kind of combinations, but the default
configuration/behaver is:
LED_STATE_OFF
Status RGB LED is off due to the fact the locker a public locker or not designed with the locker bank configuration.
LED_STATE_LOST_COIL
Inherited from V2 lock but not used within V3/V3+ lock due to missing hardware for lost coil detection.
LED_STATE_DYNAMIC_FREE
Status RGB LED is green due to the fact the locker is a dynamic and not allocated locker.
LED_STATE_DYNAMIC_IN_USE
Status RGB LED is red due to the fact the locker is a dynamic and allocated locker.
LED_STATE_OPEN_TOO_LONG
Status RGB LED is blinking red due to the fact the maximum allowed opening time has been exceeded.
LED_STATE_DENIED
Status RGB LED is fast blinking red due to the fact unlocking the locker has been denied.
LED_STATE_ASSIGNED
Status RGB LED is blinking green due to the fact the locker has been assigned.
LED_STATE_ALLOW_OPEN
Status RGB LED is fast blinking green to indicate the locker is allowed to be opened.
LED_STATE_ALLOW_REOPEN
Status RGB LED is fast blinking green to indicate the locker is allowed to be opened again.
LED_STATE_ASSIGN_ID
Status RGB LED is blinking red/green to indicate the locker is waiting to be closed in order to assign an ID (part of
configuration procedure LBC).
LED_STATE_NO_ID
Status RGB LED is 50% of the period off and 50% blinking red/green to indicate the locker is not assigned an ID (not
configured yet by LBC).
LED_STATE_UNEXPECTED
Status RGB LED is 50% of the period off and 50% blinking red to indicate the locker has been opened unexpectedly
(unallowed opening).
LED_STATE_WAIT_REPLY
Status RGB LED is fast blinking red/green to indicate the locker is waiting for a communication reply of the LBC.
LED_STATE_BLOCKED
Status RGB LED blinks red for a short period of time to indicate the locker has been blocked (locker blocker state by
Releezme).
LED_STATE_STATIC_FREE
Status RGB LED is green due tot the fact the locker is a static and not allocated locker.
LED_STATE_STATIC_IN_USE
Status RGB LED is red due to the fact the locker is a static and allocated locker.
LED_STATE_VOLTAGE_TOO_LOW
Status RGB LED blinks orange for a long period of time to indicate the lock has detected an under-voltage situation.
(This has been added to V3/V3+ with respect to V2).
LED_STATE_TEMPERATURE_TOO_HIGH
Status RGB LED blinks yellow for a long period of time to indicate the lock has detected an over temperature situation.
(This has been added to V3/V3+ with respect to V2).