Installation Manual

HW Installation manual Rev 3.10
VECOS Europe BV, Esp 237, 5633 AD EINDHOVEN, The Netherlands Page 17 of 19
9. Compliance Statement about RF, Safety and EMC
V3, HUB 3-24 and LBC 3.0 Colour Touchscreen
ISED EMC Declaration:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de Classe B est conforme à la norme Canadienne ICES-003.
FCC Information to the User:
This equipment has been tested and found to comply with the limits for a Class B digital devices, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequent energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does not cause harmful
interference to radio or television reception, which can be determine by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
 Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
 To ensure compliance with FCC regulations, use only the interface cables provided with the product, or additional
specified components or accessories that can be used with the installation of the product.
Canada & USA:
The equipment supplied is cULus approved with File number E513979, CCNs AZOT/AZOT7 according to UL 62368-1
and CSA C22.2 No. 62368-1-14 Audio/Video, Information and Communication Technology Equipment – part 1: Safety
requirements - Edition 2 - Issue Date 2014/12/01
CE:
Hereby VECOS Europe B.V. declares that the subject equipment is in compliance with the:
 EMC directive 2014/30/EU
 Low Voltage Directive2014/35/EU
 RoHS Directive 2011/65/EU and (EU) 2019/171
V3+ series
Model: V3+ and V3+HID FCC ID: 2ACYAV3NXP and IC: 25896-V3NXP
Model: V3+Legic FCC ID : 2ACYAV3LEGIC and IC: 25896-V3LEGIC
FCC and ISED Radiation Exposure Statement:
This equipment complies with FCC and Canadian radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Cet équipement est conforme a RSS-102 limites énoncées pour un environnement non contrôlé.
FCC and ISED Compliance statement:
This device complies with part 15 of the FCC Rules and to RSS-210 of Innovation, Science and Economic
Development Canada. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Cet appareil se conforme aux normes RSS 210 exemptés de license d’Innovation, Sciences et Développement
économique Canada. L’opération est soumis aux deux conditions suivantes: