Installation Manual

HW Installation manual Rev 3.10
VECOS Europe BV, Esp 237, 5633 AD EINDHOVEN, The Netherlands Page 5 of 19
Connecting the OUTPUT:
To each of the output wires attach 1 WAGO connector, so 2 WAGO connectors are needed, 1 for Black and 1 for
Red. Connecting these both of them in 1 WAGO connector, a shortcut is created!
In the empty position of the WAGO connector , the red & black wires of the HUB power cables are attached.
Black = Ground, connect to Black HUB power cable
Red = +27 volt, connect to Red HUB power cable
The Power Supplies are delivered with the connection box and the WAGO connectors already connected In case the
Power Supplies are mounted in/under/on-top of a metal locker, use self-tapping screws to connect it to ground.