Model No. 831.
Setup 1. Firmly press the thumb tab and pivot the upright up until it locks in a nearly vertical position. 2. Insert the handles into the stem until the lock pins are visible in the holes in the stern. 3. Hand Open the quick-release lever. Depress the lock pin on the stem and slide the stem up until the lock pin is visible in one of the three holes in the upright. When the stem is at the desired height, close the quick-release lever so that it is snug against the upright.
Part List/Exploded No. Qty. Drawing Model No. 831.
If the quick-release doesn't hold the stem snug in place, you will need to adjust it. Open the quick-release lever. Turn the adjustment nut clockwise one half turn while keeping the lever from turning. Close the lever. Repeat this procedure until the stem is held snug in place. If the quick-release is too snug to close, you will need to adjust it.