User manual
Manuals
Brands
Vector Manuals
Musical Instruments
CANboardXL Interface Family
48
49
50
51
52
53
54
55
56
57
Table Of Contents
1 Introduction
1.1 About this User Manual
1.1.1 Certification
1.1.2 Warranty
1.1.3 Registered trademarks
2 VN1600 Interface Family
2.1 Introduction
2.2 Accessories
2.3 Getting Started
2.3.1 Step 1: Driver Installation
2.3.2 Step 2: Device Installation
2.3.3 Step 3: Device Configuration
2.3.4 Step 4: Quick Test
2.4 VN1610
2.4.1 Main Features
2.4.2 Connectors
2.4.3 Pin Assignment CH1 and CH2
2.4.4 Technical Data
2.5 VN1611
2.5.1 Main Features
2.5.2 Connectors
2.5.3 Pin Assignment CH1 and CH2
2.5.4 Technical Data
2.6 VN1630
2.6.1 Main Features
2.6.2 Connectors Bus Side
2.6.3 Connectors USB Side
2.6.4 Bus Configuration
2.6.5 Pin Assignment CH1/3 and CH2/4
2.6.6 Pin Assignment CH5
2.6.7 Replacing Piggybacks
2.6.8 Technical Data
2.7 VN1630A
2.7.1 Main Features
2.8 VN1640
2.8.1 Main Features
2.8.2 Connectors Bus Side
2.8.3 Connectors USB Side
2.8.4 Bus Configuration
2.8.5 Pin Assignment CH1…CH4
2.8.6 Pin Assignment CH5
2.8.7 Replacing Piggybacks
2.8.8 Technical Data
2.9 VN1640A
2.9.1 Main Features
3 Common Features
3.1 Time Synchronization
3.1.1 General Information
3.1.2 Software Sync
3.1.3 Hardware Sync
4 Driver Installation
4.1 Minimum Requirements
4.2 Hints
4.3 Vector Driver Setup
4.4 Vector Hardware Configuration
4.5 Loop Tests
4.5.1 CAN
4.5.2 FlexRay
4.5.3 MOST
4.5.4 Ethernet
Ma
nual
Driver Installation
©
Vector Informatik GmbH
Version 2.0
-
51
-
5.
Click
[Start]
.
6.
You will see statistical data in t
he lower part of the window if the syst
em has been
configured properl
y.
Loop3 application
1
...
...
51
52
53
54
55
56
...
57
