User`s guide

14 Block Reference
14-10
CAN Pack
Pack individual signals into CAN message
Library
CAN Communication
Embedded Coder/ Embedded Targets/ Host Communication
Description
The CAN Pack block loads signal data into a message at specified intervals during the
simulation.
Note: To use this block, you also need a license for Simulink software.
CAN Pack block has one input port by default. The number of block inputs is dynamic
and depends on the number of signals you specify for the block. For example, if your
block has four signals, it has four block inputs.
This block has one output port, CAN Msg. The CAN Pack block takes the specified input
parameters and packs the signals into a message.
Other Supported Features
The CAN Pack block supports:
• The use of Simulink Accelerator Rapid Accelerator mode. Using this feature, you can
speed up the execution of Simulink models.